GSM notification and control module Ropam BasicGSM 2 + AT-GSM-MAG antenna

Ropam BasicGSM 2 notification and gsm control module + AT-GSM-MAG antenna

BasicGSM with 12Vdc power supply and BasicGSM-PS with built-in buffer power supply and backup power battery support. The new terminals are equipped with the latest GSM modem for 2G networks and many new resources.

• built-in GSM/DCS/EGSM modem without SIMLOCK
• GSM jamming detection (JAMMING): output status reporting and event memory recording
• 8 phone numbers, group for notification and control
• 8 inputs, NC, NO operation configuration with adjustable sensitivity up to 60,000 [ms or s]
• AI analog input 0-10V with scaling to physical value (e.g. temp=°C, RH=%, p=kPa)
• FAC input to control AC (or DC) voltage of primary power supply e.g. panel, controller, DC power supply
• 4 controlled outputs via SMS, CLIP, DTMF, failure, no AC, JAMMING
• O1 12VDC/1A output with short circuit and overload protection, O2-O4 OC 100mA outputs
• transmission from SMS/VOICE/CLIP inputs
• Any SMS and VOICE messages ( VSR-2 required) at system events: inputs, temp.
• TerminalSMS: function of transmitting and receiving SMS via RS232TTL port from DTE devices (PLC, controllers, etc.) without #AT commands, ASCI codes, BasicGSM works like a modem, GSM terminal (DCE),
• KeyGSM: function of controlling outputs via telephone number identification (CallerID so called, CLIP) or SMS for programmed group of numbers (recipients), SMS control confirmation for CLIP and SMS control
• audio integration with intercoms and intercoms
• temperature measurement from TSR-1 sensor, thermostat on 2 outputs with hysteresis
• two-way audio system, object eavesdropping (AMR-1)
• RTC clock with battery backup (power restarts)
• communication test function: SMS, SMS STATUS, CLIP
• optical signaling of GSM operation and range
• event memory; 1000 events with overwriting
• functions for limiting the cost and number of transmissions
• USSD code support (pre-paid card control and service change)
• 12V/DC power supply with DC voltage control (<11V).

• logic functions (9) for arguments: inputs, outputs, markers (binary value 0/1), temperature thresholds, analog input thresholds, failures, timers, binary values
• time-logic functions (8) as programmable time relays, triggers and reset timers (blocks) identical to the arguments in the logic functions and the results are written outputs or markers
• 4 24h timers for LogicProcessor option

• cooperation with MSR Manager station (RopamMSR controller, in development),
• cooperation with Kronos NET station (RopamDirect controller) - encrypted TCP/IP transmission, two IP addresses, backup SMS transmission, parallel operation with mode
• SMS/VOICE notification

• electronic burglar alarm systems,
• home automation systems,
• programmed time relay functions
• control and control systems via GSM network,
• temperature control and supervision systems,
• systems of control and supervision of analog value from sensors with 0-10V output,
• control and supervision systems for power transmission networks,
• access control systems,
• transmission and control of processes,
• integration with intercoms: audio,
• SMS and e-mail modem for simple PLCs